discuss-gnuradio
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] Tx Burst for Chirp signals


From: CEL
Subject: Re: [Discuss-gnuradio] Tx Burst for Chirp signals
Date: Thu, 10 May 2018 09:05:08 +0000

Hi!

your receiver low pass filter is incorrectly parameterized, probably
(sampling rate isn't 32 MS/s). And so is the rest of your flow graph –
your USRP is using a sampling rate of 2 MS/s, but you act as if it's
running at 32 MS/s. Start with 2 MS/s and make it work with that – then
later scale up (the processing load of 32 MS/s is harder than you
probably think).
Remember that GNU Radio is pure DSP, so all the axis labels on your
visualizations are just that – labels, interpreting relative
frequencies (i.e. frequencies divided by the sampling rate) by
multiplying them with the value you entered in bandwidth. The "physical
meaning" of your signal is defined by the sampling rate of your
physical device.
Thus, you want to use the same sampling rate everywhere in your flow
graph. These things mean! something.

Best regards,
Marcus

On Thu, 2018-05-10 at 08:31 +0000, Yeo Jin Kuang Alvin (IA) wrote:
> Hi everyone,
>  
> There are two questions that I would like to ask.
>  
> 1)      I would like to transmit burst signals of the chirp generated
> from the flowgraph attached. I tried using the “stream to Tagged
> stream” way, but when I ran the GNU Radio Companion, it’s being
> transmitted continuously. Nothing seems to be happening. Am I doing
> something wrong and is there a better way for burst transmission?
>  
> 2)      I noticed something with the sampling rates of the blocks.
> When I use the same sampling rate for all the blocks, I get underflow
> “UUU”. However, when I changed all the block’s sampling rate to 32MHz
> and leave the USRP Sink and Source to 2MHz, no underflow is seen but
> there is still overflow (seen in the attached screenshot).
>  
> What is the difference between the USRP’s sampling rate compared to
> the other block’s sampling rate?
>  
> Thank you in advanced!
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

Attachment: smime.p7s
Description: S/MIME cryptographic signature


reply via email to

[Prev in Thread] Current Thread [Next in Thread]