[Emacs-diffs] Changes to emacs/INSTALL.CVS,v

[Glenn Morris]

CVSROOT:        /sources/emacs
Module name:    emacs
Changes by:     Glenn Morris <gm>       08/06/08 19:11:43

Index: INSTALL.CVS
===================================================================
RCS file: /sources/emacs/emacs/INSTALL.CVS,v
retrieving revision 1.21
retrieving revision 1.22
diff -u -b -r1.21 -r1.22
--- INSTALL.CVS 8 Jun 2008 19:00:38 -0000       1.21
+++ INSTALL.CVS 8 Jun 2008 19:11:43 -0000       1.22
@@ -18,9 +18,7 @@
 before it builds the final Emacs binary.
 
 If 'make bootstrap' fails, it may be necessary to do 'make maintainer-clean'
-followed by configure before trying it again.  (Occasionally the loaddefs.el
-file gets into a bad state due to changes in the Lisp libraries; this procedure
-forces it to be regenerated.)
+followed by configure before trying it again.
 
 Normally, it is not necessary to use "make bootstrap" after every CVS
 update.  Unless there are problems, we suggest using the following
@@ -37,20 +35,22 @@
 (If you want to install the Emacs binary, type "make install" instead
 of "make" in the last command.)
 
-Occasionally the file "lisp/loaddefs.el" (and similar *-loaddefs.el
-files in some subdirectories of lisp/, e.g. mh-e/ and calendar/) will
-need to be updated to reflect new autoloaded functions.  If you see
-errors (rather than warnings) about undefined lisp functions during
-compilation, that may be the reason.  Another symptom may be an error
-saying that "loaddefs.el" could not be found; this is due to a change
-in the way loaddefs.el was handled in CVS, and should only happen
-once, for users that are updating old CVS trees.  Finally, sometimes
-there can be build failures related to *loaddefs.el.  In that case,
-delete them before following the instructions below to update them.
+Occasionally the file "lisp/loaddefs.el" (and similar automatically
+generated files, such as esh-groups.el, and *-loaddefs.el in some
+subdirectories of lisp/, e.g. mh-e/ and calendar/) will need to be
+updated to reflect new autoloaded functions.  If you see errors (rather
+than warnings) about undefined lisp functions during compilation, that
+may be the reason.  Another symptom may be an error saying that
+"loaddefs.el" could not be found; this is due to a change in the way
+loaddefs.el was handled in CVS, and should only happen once, for users
+that are updating old CVS trees.  Finally, sometimes there can be build
+failures related to *loaddefs.el (e.g. "required feature `esh-groups'
+was not provided").  In that case, follow the instructions below.
 
 To update loaddefs.el (and similar files), do:
 
   $ cd lisp
+  $ make autogen-clean
   $ make autoloads EMACS=../src/emacs
 
 If either of the above partial procedures fails, try "make bootstrap".