Re: [O] Setting multiple variables for code blocks in one property drawer

[Eric Schulte]

Viktor Rosenfeld <address@hidden> writes:

> Hi,
>
> after following the discussion about the new BABEL syntax I was under
> the impression that the following should work to set two variables in
> one PROPERTIES drawer:
>
> :PROPERTIES:
> :var: foo=1
> :var+: bar=2
> :END:
>
> However, the definition of bar is ignored. It turns out that there can
> only be one :var: or :var+: entry in a drawer and the latter can only be
> used to append to inherited entries, but not to those defined in the
> same drawer. Is this the intended behavior? How would I define multiple
> variables in a drawer (except for putting them all on one line)?
>
> Thanks,
> Viktor
>

You are correct, I believe this is a bug.  I've just pushed up a fix, so
your example above should now work as expected.

Thanks,

-- 
Eric Schulte
http://cs.unm.edu/~eschulte/