Re: [O] Exporting caption with raw results from inline source blocks

[John Hendy]

On Fri, Apr 26, 2013 at 7:41 AM, Andreas Leha
<address@hidden> wrote:
> John Hendy <address@hidden> writes:
>
>> On Fri, Apr 26, 2013 at 6:49 AM, Andreas Leha
>> <address@hidden> wrote:
>>> Andreas Leha <address@hidden> writes:
>>>
>>>> Hi all,
>>>>
>>>> I am experiencing problems when exporting a document with inline source
>>>> blocks in captions, when I want to export raw results.
>>>>
>>>> I guess the culprit are the 'raw' results.  What should I do instead?
>>>>
>>>> Here is a MWE that does not export properly to LaTeX:
>>>>
>>>>
>>>> #+PROPERTY: exports results
>>>> #+PROPERTY: results raw
>>>>
>>>> * Caption with inline source
>>>>
>>>> #+name: theplot
>>>> #+begin_src R :results graphics :file someplot.pdf
>>>>   plot(1:(10+1), 1:(10+1))
>>>> #+end_src
>>>>
>>>> #+caption: There are src_R{10+1} points in this plot
>>>> #+results: theplot
>>>> [[file:someplot.pdf]]
>>>>
>>
>> Do you need raw results? It works for me if I just remove the
>> =#+PROPERTY: results raw= line. I'm wondering if that property and the
>> =:results graphics= in your code block conflict?
>>
>> My file:
>>
>>
>> #+PROPERTY: exports results
>>
>>
>> * Caption with inline source
>>
>>
>> #+name: theplot
>> #+begin_src R :results graphics :file someplot.pdf
>>
>>   plot(1:(10+1), 1:(10+1))
>> #+end_src
>>
>>
>> #+caption: There are src_R{10+1} points in this plot
>> #+results: theplot
>>
>> [[file:someplot.pdf]]
>>
>> PDF output attached. With the results raw property line, I got goofy
>> caption alignment and it just said "points in this plot" instead of
>> the full line.
>>
>>
>
> Hi John,
>
> thanks for testing.  You see the same behaviour that I see.  This is a
> bug, IMO.
>
> Do I need the raw results?  Well, it only differs in the typeface, so I
> can hardly say, I 'need' them.  But in longer and more elaborate
> captions as for scientific publications, the results should appear as
> ordinary text, I think.
>

I don't get anything with =:results output raw= even from a normal block...

#+begin_src R :results output raw :exports results
10+1
#+end_src

#+RESULTS:
[1] 11


That exports a blank LaTeX document for me:

\section*{Caption with inline source}
\label{sec-1}
% Emacs 24.3.1 (Org mode 8.0.1)
\end{document}


Perhaps that's the problem? There was some discussion recently about
the point of raw results; This makes me wonder if it was removed?

If I change to =:results value= and add =:wrap latex= above, I get
regular text exported (not inside =\texttt=). It doesn't seem that
=:wrap latex= works for inline blocks, though?


John

> Thanks again for the confirmation.
>
> Best,
> Andreas
>
>