espressomd-users
[
Top
][
All Lists
]
Advanced
[
Date Prev
][
Date Next
][
Thread Prev
][
Thread Next
][
Date Index
][
Thread Index
]
[ESPResSo-users] Error shows particle coordinate out of range
From
:
padidela uday
Subject
:
[ESPResSo-users] Error shows particle coordinate out of range
Date
:
Thu, 13 Mar 2014 16:11:26 +0530
Hello everyone,
I had simulated a colloidal system with WCA potential. After equilibrating the system the simulation was crashed and it shows and error
which is shown below.
I tried with smaller time steps and increased the warmup steps of the system, but couldnt get a solution for this problem.
Can you please suggest me?
Thank you
Uday
reply via email to
[Prev in Thread]
Current Thread
[
Next in Thread
]
[ESPResSo-users] Error shows particle coordinate out of range
,
padidela uday
<=
Re: [ESPResSo-users] Error shows particle coordinate out of range
,
Owen Hickey
,
2014/03/13
Prev by Date:
Re: [ESPResSo-users] LB as a thermostat
Next by Date:
[ESPResSo-users] error message during "make" step in installation
Previous by thread:
[ESPResSo-users] Discrepancy in velocity fluid flow between two plates
Next by thread:
Re: [ESPResSo-users] Error shows particle coordinate out of range
Index(es):
Date
Thread