Re: [ESPResSo-users] Increase the lattice boltzmann agrid but got error.

[Florian Weik]

Hi,

this is an error message from the P3M (Electrostatics). This is an indication that something else is wrong.

It would be easier to help you if you would post a minimal example that reproduces you problem. In principle

you should be able to change agrid.

Cheers,

Florian

On Wed, May 27, 2015 at 3:30 AM, Joe Ada <address@hidden> wrote:

Hi Guys,

I found that when I increase the agrid of LB fluidics, without changing anything else, I got the following error:

Complex value is not zero (i=16774,data="">

I wanted to increase the size of the simulation cube. Because of the limit of memory, I can only increase agrid. Is there a upper limit of it?

Joe

--

Florian Weik, Dipl.-Phys.,
Institut für Computerphysik, Allmandring 3, D-70569 Stuttgart
Phone: +49-711-685-67703

Public Key 0x0562F11D Fingerprint 3294 6360 EC93 37A3 BD40  F597 0BAD 3AF8 0562 F11D