[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Fab-user] Error Message "err: stdin: is not a tty"
From: |
Eric Falconnier |
Subject: |
[Fab-user] Error Message "err: stdin: is not a tty" |
Date: |
Wed, 6 Aug 2008 19:09:42 +0200 |
Hi,
When I run a command on remote hosts, I always get this error message
after the correct output :
[remote host ip] err: stdin: is not a tty
I discovered by reading the source code that this error is connected
to the default fab_shell command which is set to bash -l -c "%s". If I
replace this command by bash -c "%s", the error messages don't show up
anymore.
( set(fab_shell = '/bin/bash -c "%%s"') at the top of the fabfile )
Is this a special case due to my remote hosts configurations ?
Thanks in advance,
Eric.
- [Fab-user] Error Message "err: stdin: is not a tty",
Eric Falconnier <=