Hi all,
I am new to fluidsynth and i tried it to run it on my raspberry pi
computer.
its a small ARM board with a 700 mhz processor and 256 mb ram.
When i tried it it played the file for a few seconds and then it strated
to kind of grind or hum. sounded like a saw wave tone got quite low but
went up and down the scale.
here's the output of the console:
$ fluidsynth -a alsa /usr/share/sounds/sf2/FluidR3_GM.sf2 10.mid
FluidSynth version 1.1.5
Copyright (C) 2000-2011 Peter Hanappe and others.
Distributed under the LGPL license.
SoundFont(R) is a registered trademark of E-mu Systems, Inc.
fluidsynth: warning: Failed to pin the sample data to RAM; swapping is
possible.
Parameter '10.mid' not a SoundFont or MIDI file or error occurred
identifying it
.
fluidsynth: warning: Requested a period size of 64, got 256 instead