[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [ft-devel] porting: Where should i start debugging
From: |
duhuanpeng |
Subject: |
Re: [ft-devel] porting: Where should i start debugging |
Date: |
Sun, 4 Mar 2018 00:41:14 +0800 |
Dear Werner,
>If in doubt I suggest that you primarily have a look at the FreeType demo
>programs,
> which use a large portion of the provided API.
By the way, my Linux box is headless, so I run a vnc4server. But I get this
result:
address@hidden:~/ft2demos-2.9/bin$ ./ftview 16 Gb16st.pcf.Z
could not allocate display surface
error = 0x0000, no error
address@hidden:~/ft2demos-2.9/bin$
When I become root to run this program, I still get the same result.
Can I run "ftview" in text mode?
I am going to run my code on my target board tomorrow.
Thank you again.
Regards,
duhuanpeng