[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Geiser-users] how to start?
From: |
Steve Weeks |
Subject: |
Re: [Geiser-users] how to start? |
Date: |
Fri, 4 Nov 2011 19:29:31 -0400 |
oops fat fingered the email...
I have emacs 23.2.1, guile 2.0.3, geiser 0.1.3 (and paredit) installed and seeming to mostly work. I am new to all three and am stuck trying to get started. I can start the REPL (M-x run-guile).
Some how have guile's %load-path screwed up. I edited the .guile file and added:
(set! %load-path (cons "/home/steve/new/path" %load-path))
This shows up fine within geiser's REPL, Then I changed the path in the .guile file, but geiser doesn't see the change. If I run guile from the command line, the change is there, but not within geiser.
Any ideas?
Thanks,
Steve
On Fri, Nov 4, 2011 at 7:07 PM, Steve Weeks
<address@hidden> wrote:
I have emacs 23.2.1, guile 2.0.3, geiser 0.1.3 (and par