Paul,
can you please post your volume spec files and the command line with
which you are trying to start glusterfs?
avati
2007/9/7, Paul Jochum < address@hidden
<mailto:address@hidden>>:
Hi all:
I am trying out glusterfs 1.3.1 (from the download page), for the
first time. It compiled and installed fine. I am running a simple
configuration of one client and one brick, using the supplied example
/etc/glusterfs vol files (just changed the address in the client's
vol
file), and seems to run on the server. When I try to run it on the
client, it immediately fails with the message:
glusterfs: could not open specfile
On the client's log file, I am seeing:
2007-09-06 23:15:04 E [ protocol.c:253:gf_block_unserialize_transport]
trans: EOF from peer (192.168.1.225:6996 <http://192.168.1.225:6996>)
On the server's log file, I am seeing:
2007-09-06 23:14:39 C [tcp.c:81:tcp_disconnect] server: connection
disconnected
2007-09-06 23:14:39 E [server-protocol.c:197:generic_reply] server:
transport_writev failed
I can ping, and ssh between the two hosts. I have disabled
iptables
and ip6tables on the server and client.
So, I assume that I am missing something basic here, but don't
know
where to start looking. Any suggestions?
thanks,
Paul Jochum
_______________________________________________
Gluster-devel mailing list
address@hidden <mailto:address@hidden>
http://lists.nongnu.org/mailman/listinfo/gluster-devel
<http://lists.nongnu.org/mailman/listinfo/gluster-devel>
--
It always takes longer than you expect, even when you take into
account Hofstadter's Law.
-- Hofstadter's Law