Re: [Gnewsense-dev] gNewSense/mipsel-l Boot Problems

[Vince Ying]

Yes, I used ext2, set mount point to /, bootable, tried sizes of 7GB
and 130GB, no other special options.

On 5/8/09, Karl Goetz <address@hidden> wrote:
> On Fri, 8 May 2009 11:58:38 -0700
> Vince Ying <address@hidden> wrote:
>
>> When attempting to execute the following command on the Yeeloong
>>
>> load /dev/fs/address@hidden/boot/vmlinux-2.6.27.7-libre
>>
>> from the instructions at
>>
>> http://wiki.gnewsense.org/Projects/GNewSenseToMIPS
>>
>> The system says it can not find the partition.  I have tried wd0, and
>> wd0a through wd0c.  I think it should be wd0a, the root partition is
>> #1.  devls lists wd0 as the DISK device.
>>
>
> Did you use ext2 for the filesystem? (The current installer uses ext2
> by default on / , so if you went a reasonably default install you
> should be).
> kk
>
> --
> Karl Goetz, (Kamping_Kaiser / VK5FOSS)
> Debian user / gNewSense contributor
> http://www.kgoetz.id.au
> No, I won't join your social networking group
>