[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Plots not showing
From: |
Ben Abbott |
Subject: |
Re: Plots not showing |
Date: |
Tue, 28 Oct 2008 14:54:29 -0400 |
On Tuesday, October 28, 2008, at 12:56PM, "Mark Abbott" <address@hidden> wrote:
>I've just installed Octave 3.0.2 and gnuplot 4.2.3 on MacOSX 10.4.11
>PowerPC. The install itself worked fine (as far as I know) and
>Octave works great.
>
>However, I can't get plots to show. When asking for a plot, semilog
>etc, the computer pauses to do the work, but then nothing shows -
>Octave just goes to the next prompt. There are no error messages
>(e.g. like the ones you get if gnuplot isn't installed).
>
>Any ideas would be most appreciated. I'm not a Terminal expert, so
>you'll have to type slowly, I'm afraid.
>
>Thanks,
>
>Mark
Hi Mark,
Where did you get your copy of Octave?
Assuming you installed a binary distribution, have you installed AquaTerm as
well? If not you can install AquaTerm using Fink, DarwinPorts, or download the
binary
http://sourceforge.net/projects/aquaterm/
Ben