[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
4.2.4-1 GNUPLOT, 3.0.3 Octave Behaviour
From: |
gennarim |
Subject: |
4.2.4-1 GNUPLOT, 3.0.3 Octave Behaviour |
Date: |
Wed, 08 Jul 2009 20:23:22 -0400 |
Gentlemen:
I know this problem has been seen before and solved, but I could not
find
the solution in any of the archived discussions. If you have time,
please
advise. The jist of the matter is as follows:
PC/Intel 448 Mhz.OS: Windows 98SE
Cygwin Operating System BASH Layer: 2.1.15
Octave Application: 3.0.3
GNUPLOT Application: 4.2.4-1
Run Octave:
Assign; x= values
Simple plot command: plot(x)
Within OCTAVE window :
GNUPLOT generates 'set terminaal aqqua 1 enhanced' message
GNUPLOT gemerates 'set terminal type first' message
GNUPLOT enumerates the X array with error messages.
..
OCTAVE prompt returns.
GNUPLOT plot window does not open
GNUPLOT command window does not open.
Within OCTATVE:
Tried setenv("GNUTERM","unknown")
Result: Same plot error: had no effect
Tried setenv("GNUTERM","vttek")
Result: Generate character output in OCTAVE WINDOW,no plot
Tried setenv("GNUTERM","")
Result: Generated character stream output in OCTAVE window, no plot
From CYGWIN OS,
Tried export GNUTERM="unknown". then OCTAVE, then plot(x); ERROR/halt
Tried export GNUTERM="". then OCTAVE, then plot(x); ERROR/halt
..
etc. with ERROR/halt, no plot..
Sincerely,
MJG
- 4.2.4-1 GNUPLOT, 3.0.3 Octave Behaviour,
gennarim <=