[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: how to compile lapack so that it can be used correctly during instal
From: |
tmacchant |
Subject: |
Re: how to compile lapack so that it can be used correctly during installation of octave? |
Date: |
Sun, 4 May 2014 00:10:41 -0700 (PDT) |
> Hi,
>I'm trying to install the latest octave 3.8.1 from source in a cluster
running redhat+IBM LSF. I don't have write access to anywhere else except my
own home dir, that's why I have to install octave from source. The blas and
lapack provided by the cluster does not work so I have to build them by
myself. I have now finished compiling both blas and lapack and passed the
./configure, but when I run make, an error is reported as follows:
>From snapshot screen, you are using the Ubuntu. For Ubuntu, I have built
octave-3.8.1 from source
(on both 32 bit and 64 bit 12.04 LTS).
I have gotten a lot of dependencies (including prebuild libblas and lapack)
according to the instructions from:
http://blogs.bu.edu/mhirsch/2013/12/compiling-octave-3-8/
(The blog was described for the Ubuntu 13.10 and 12.04)
If you do not have any special reason to use self-build lapack, please use
pre-build one.
Regards
Tatsuro
--
View this message in context:
http://octave.1599824.n4.nabble.com/how-to-compile-lapack-so-that-it-can-be-used-correctly-during-installation-of-octave-tp4663905p4663906.html
Sent from the Octave - General mailing list archive at Nabble.com.
- Re: how to compile lapack so that it can be used correctly during installation of octave?,
tmacchant <=