Re: [Info-mtools] GNU mtools 4.0.19 released

[Alain Knaff]

Hi,

On 17/10/2018 18:47, Pali Rohár wrote:
> On Sunday 30 September 2018 21:42:59 Pali Rohár wrote:
>> Hi! Thank you for a new release!
>>
>> With new release I spotted two problems:
>>
>> 1) Problem in mcopy which cause uninitialized data in FAT entry is still not 
>> fixed
>>
>>    https://lists.gnu.org/archive/html/info-mtools/2014-08/msg00000.html
>>
>> 2) In mformat.c is:
>>
>>              /* Number of sectors must fit into 32bit value */
>>              if (tot_sectors > 0xFFFFFFFF) {
>>                      fprintf(stderr, "Too few sectors\n");
>>                      exit(1);
>>              }
>>
>>    But error message should be "Too many sectors".
> 
> Alain, are you going to fix these two problems?
> 

Unfortunately, at the moment I'm busy with some other project, but don't
worry, I'll get back to this end end of November.

Regards,

Alain