[K-mib-ppc] pre8 -testing

[Hard Mac]

Today I tested pre-8 on a G4 cube, 450 Mhz, 256 MB RAM, 
ATI Rage 128 Pro (AGP 2X) video card

At startup there was a lot more info about the airport card etc. than was on 
the dual usb ibook at startup. Is it possible to save/output this log for you 
all to see?


After startx I get the screen turn black for a couple seconds and then the 
following errors:



---snip---

(EE) R128(0): Cannot read V_BIOS (5)
(EE) R128(0): No DFP Detected

Fatal server error:
Caught signal 7. Server aborting

-----snip---

XIO:  fatal IO error 104 (Connection reset by peer) on X server ":0.0"
after 0 requets (0 known processed) with 0 events remaining.
xauth: (argv):1: bad display name "knoppix:0" in "remove" command

---snip---



Would the XFree86.0.log file be better to see? If so can someone tell me how to 
export/save it a my mac's HFS system so I can send it?


I tried your suggestion mentioned previously of adding:

Option "UsbDev"  "true"

I added it under the: Section "InputDevice"

and it produced the same errors. Soon to try on the ibook and I will inform you 
of the results..



Thomas







Need a new email address that people can remember
Check out the new EudoraMail at
http://www.eudoramail.com