Re: bi-arch build problem: cannot build 64-bit libs on ppc64

[Maynard Johnson]

Peter O'Gorman wrote:
> Maynard Johnson wrote:
>
>   
> >    #> ./libtool --version
> >    ltmain.sh (GNU libtool) 1.5.24 (1.1220.2.455 2007/06/24 02:13:29)
> >
> >    Copyright (C) 2007  Free Software Foundation, Inc.
> >    This is free software; see the source for copying conditions.  There
> > is NO
> >    warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR
> > PURPOSE.
> >     
>
> Is it possible that while your ltmain.sh comes from libtool-1.5.24, your
> configure was generated using an earlier version of libtool.m4?
>
> Check your aclocal.m4 (and the m4 files it includes), for 'serial ??
> AC_PROG_LIBTOOL'. For 1.5.24 that should be 'serial 51 AC_PROG_LIBTOOL'.
>   
I started out with libtool 1.5.22 installed in /usr on my system.  I 
installed 1.5.24 in /usr/local before posting to the list.  I thought I 
had regenerated everything in my project from scratch after installing 
1.5.24, but when I looked at aclocal.m4, I saw 'serial 48 
AC_PROG_LIBTOOL'.  So I started again from scratch in a new session, 
making sure that the libtool in my path was 1.5.24.  I checked out my 
project fresh from CVS so that there were no old generated files; ran 
the libtoolize, aclocal, autoheader, automake, and autoconf; then did 
the configure as before (with CFLAGS and CXXFLAGS = "-m64".  Same 
result.  I still see 'serial 48 AC_PROG_LIBTOOL' in aclocal.m4.  What am 
I missing?

Thanks!
-Maynard


> Thanks,
> Peter
>