Re: staff-position single multimeasure rest

[Mats Bengtsson]

If you use the correct combination of upper case and lower case letters,
in MultiMeasureRest, I think your solution will work.

   /Mats

David Bobroff wrote:
> I want to adjust the staff-position of a single MultiMeasureRest.  That
> is, I have an R1 that I want to place hanging from the top staff line
> rather than the center line.  This will keep it out of the way of some
> cue notes.  I tried:
>
> \once \override Staff.MultimeasureRest #'staff-position = #5
>
> But it does not affect the single "MultiMeasureRest".  How do I do this?
>
> -David
>
>
>
> _______________________________________________
> Lilypond-user mailing list
> address@hidden
> http://mail.gnu.org/mailman/listinfo/lilypond-user

--
=============================================
        Mats Bengtsson
        Signal Processing
        Signals, Sensors and Systems
        Royal Institute of Technology
        SE-100 44  STOCKHOLM
        Sweden
        Phone: (+46) 8 790 8463                         
        Fax:   (+46) 8 790 7260
        Email: address@hidden
        WWW: http://www.s3.kth.se/~mabe
=============================================