Re: Undefined control sequence. \embeddedps

[n0oct]

On Thu, 17 Nov 2005 14:54:42 +0100
Mats Bengtsson <address@hidden> wrote:

> That's only needed to process the documentation. You can safely change
> the line in configure.in that says
> STEPMAKE_PROGS(MAKEINFO, makeinfo, REQUIRED, 4.7)
> to read 4.6 instead and then run
> ./autogen
> to generate and run a new configure that accepts makeinfo 4.6.

I did this, and it still spits out the error that makeinfo needs to be
>= 4.7.  Is there something I can edit by hand in configure?

> It may happen that when you run 'make' it will break at the end
> complaining about errors, but those will only affect the documentation
> and 'make install' should install everything else correctly so you can use
> the program.
> 
>    /Mats



-- 

72, Jim N0OCT