Re: Divisi lyrics

[Mats Bengtsson]

As you might know, the documentation is going through a major revision 
for the
moment. Could you please try to read Section "Voices contain music" in
http://web.uvic.ca/~gperciva/  -> GDP Docs -> Learning Manual
and comment on if you can figure out the answer to your question there.
(Since I know the answer, I know that it's explained there, even though 
your
particular question isn't explicitly covered).

   /Mats

Peter Siepmann wrote:
> Thank you very much for your reply, Mats.
>
> I'm using 2.10.25 and, as you say, the fragment I sent before compiles 
> fine on its own.  The troubles arise when I put (single voice) notes 
> either side of it, such as :
>
> R1 r4 fis2 eis4 dis2 cis4. cis8 b'4 b2 ais4 gis2. cis,4
> << { \voiceOne dis2( eis8 fis gis4) fis2 fis4. fis8 fis4 fis2 ~ fis4 
> gis2 ais4 r4} \\
>      \new Voice = "vII" { \voiceTwo dis,2 (eis8 dis cis b) ais2 b4. 
> dis8 cisis4 dis2( ais4) cis2 fis4 r4}
>      \lyricsto "vII" \new Lyrics {
>        mun -- di, mi -- se -- re -- re no -- bis.
>      }
>    >>
> cis8. cis16 cis2 cis4 b2 cis4 r8 cis8 cis4 cis cis8 cis4 cis8 b2 cis4 r4
>
> You see, this is part of a much larger score, and the lyrics to most 
> of the music is held in a separate \lyricmode { } block.  But there 
> are one or two occasions when a single line splits into two parts; at 
> these points, the main lyrics seem to disappear, and so I tried coding 
> them in alongside the music as in the example above...
>
> Your continued assistance is most gratefully appreciated!
>
> Peter

--
=============================================
        Mats Bengtsson
        Signal Processing
        Signals, Sensors and Systems
        Royal Institute of Technology
        SE-100 44  STOCKHOLM
        Sweden
        Phone: (+46) 8 790 8463                         
       Fax:   (+46) 8 790 7260
        Email: address@hidden
        WWW: http://www.s3.kth.se/~mabe
=============================================