RE: Repeats

[Trevor Daniels]

How about "Repeating note patterns"?  Perhaps an example of
\repeat unfold could be included here too, then.

Trevor D

> -----Original Message-----
> From: Mats Bengtsson [mailto:address@hidden
> Sent: 22 February 2008 15:11
> To: address@hidden
> Cc: address@hidden; Palmer, Ralph
> Subject: Re: Repeats
>
>
> Also, could we find a better term than "Measure
> repeats", so that it
> covers also \repeat percent 4 { c4 }. I think we
> used to have the title
> "percent repeats" in some old version of the
> manual, but I'm not sure
> if that rings a bell either, for most readers.
>
>     /Mats
>
> Mats Bengtsson wrote:
> > Don't forget that it probably isn't obvious to
> most first time readers
> > that
> > a tremolo or measure repeat is even considered
> a repeat, i.e. they won't
> > look in the section called repeats.
> > Also, don't forget about \repeat unfold, which
> actually is very useful
> > in some circumstances, but perhaps doesn't
> require a subsection of its
> > own.
> >
> >   /Mats
> >
> > Trevor Daniels wrote:
> >> Hi Ralph
> >>
> >> I'd go for the simpler structure:
> >>
> >> 1.4 Repeats
> >> 1.4.1 Repeat syntax
> >> 1.4.2 Normal repeats
> >> 1.4.3 Manual repeat commands
> >> 1.4.4 Tremolo repeats
> >> 1.4.5 Measure repeats
> >>
> >> This puts the syntax at the front, as you wanted, and
> >> removes the ugly, somewhat artificial, separation into
> >> Writing repeats and Other repeats.  Also
> removing a level is
> >> good.  You could add "Writing" before headings 2-5, to
> >> distinguish them from the syntax section but I
> don't think
> >> that's necessary.
> >>
> >> Trevor D
> >>
> >> -----Original Message-----
> >> From:
> address@hidden
> >>
> [mailto:lilypond-user-bounces+t.daniels=treda.co.u
> address@hidden
> >> On Behalf Of Palmer, Ralph
> >> Sent: 21 February 2008 21:04
> >> To: address@hidden
> >> Subject: GDP: Repeats
> >>
> >>
> >> Hi, All -
> >> I'm currently working on rewriting Repeats in
> the Notation
> >> Reference, and I don't care for the existing structure.
> >> Currently, it looks like this:
> >> 1.4 Repeats
> >> 1.4.1 Writing repeats
> >> 1.4.1.1 Repeat syntax
> >> 1.4.1.2 Normal repeats
> >> 1.4.1.3 Manual repeat commands
> >> 1.4.2 Other repeats
> >> 1.4.2.1 Tremolo repeats
> >> 1.4.2.2 Measure repeats
> >> However, since Repeat syntax discusses the
> common syntax for
> >> all the repeats, it would seem to make more
> sense to take it
> >> out of the section dealing with normal. I'd
> like to suggest:
> >> 1.4 Repeats
> >> 1.4.1 Repeat syntax
> >> 1.4.1.1 Repeat syntax and types of repeats
> >> (introduction of the syntactic construct)
> >> (following types of repetition are supported . . .)
> >> 1.4.2 Writing repeats
> >> 1.4.2.1 Normal repeats (I'd prefer a better term than
> >> "normal")
> >> 1.4.2.2 Manual repeat commands
> >> 1.4.2.3 Tremolo repeats
> >> 1.4.2.4 Measure repeats
> >> It might also make sense to split 1.4.1.1 into 1.4.1.1
> >> Repeat syntax, followed by 1.4.1.2 Types of repeats
> >> supported.
> >> Comments, please?
> >> Ralph
> >>
> >>
> >>
> >> _______________________________________________
> >> lilypond-user mailing list
> >> address@hidden
> >> http://lists.gnu.org/mailman/listinfo/lilypond-user
> >>
> >
>
> --
> =============================================
>       Mats Bengtsson
>       Signal Processing
>       School of Electrical Engineering
>       Royal Institute of Technology (KTH)
>       SE-100 44  STOCKHOLM
>       Sweden
>       Phone: (+46) 8 790 8463
>         Fax:   (+46) 8 790 7260
>       Email: address@hidden
>       WWW: http://www.s3.kth.se/~mabe
> =============================================
>
>