[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Whole measure rest after changing staff
From: |
Mats Bengtsson |
Subject: |
Re: Whole measure rest after changing staff |
Date: |
Fri, 23 Jan 2009 14:06:25 +0100 |
User-agent: |
Thunderbird 2.0.0.5 (X11/20070716) |
It's much easier to answer your question if you provide a complete (but
small) example
of what you have tried. However, if you read at
http://lilypond.org/doc/v2.12/Documentation/user/lilypond-learning/Fixing-overlapping-notation#index-MultiMeasureRest_002c-example-of-overriding
you will learn how to set the vertical position of the whole bar rest
(set the staff position to 0 to get the default
position).
/Mats
Stefan Waler wrote:
Hi,
I would like to write a whole measure rest into a staff which I "left"
just before - is this possible somehow? I tried using two voices with
the result that the rest is is not centered vertically anymore (which
is, BTW, always very annoying anyway).
Thanks for your help!
Stefan
c1 |
\set followVoice = ##t
\change Staff=RHStaff
% the whole measure rest should remain in the LHStaff AND begin
% at the same time as the following note
c8
_______________________________________________
lilypond-user mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/lilypond-user
--
=============================================
Mats Bengtsson
Signal Processing
School of Electrical Engineering
Royal Institute of Technology (KTH)
SE-100 44 STOCKHOLM
Sweden
Phone: (+46) 8 790 8463
Fax: (+46) 8 790 7260
Email: address@hidden
WWW: http://www.s3.kth.se/~mabe
=============================================