|
From: | Wim van Dommelen |
Subject: | Re: convert-ly 2.17.6 does nothing |
Date: | Fri, 16 Nov 2012 23:42:33 +0100 |
Hi Noeck, I think that problem does point you really to the paths configured. Check (on Linux or OSX, sorry I don't use Wxx for this) these command-line commands: $ which lilypond $ which convert-ly $ lilypond --version $ convert-ly --version (Wxx doesn't know the "which" commands, but should produce output with the --version switches) Check for consistency in paths, versions, etc. Match it with what Frescobaldi tells you (menu settings -- configure Frescobaldi). If the convert-ly (menu Lilypond -- source -- etc.) stays greyed out, check if you did not already convert it (once is enoough!), next run should produce a window stating this file is already up-to-date, Frescobaldi might also puts some comments in your file to remember this. Try setting the version-number in the file to something else. Regards, Wim. (mail me the output if you have troubled interpreting) On 16 Nov 2012, at 20:51 , Noeck wrote:
|
[Prev in Thread] | Current Thread | [Next in Thread] |