[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: Contolling Hairpin spans again
From: |
Peter Gentry |
Subject: |
RE: Contolling Hairpin spans again |
Date: |
Fri, 6 Sep 2013 15:30:42 +0100 |
Hello Kieren
I may have jumped the gun a bit (again). It doesn't matter that Midi output is
changed (for debugging) so long as the bar lengths
are unchanged.
I haven't seen the e2*1/2 syntax before. Does that "mean" engrave a minim but
reduce its value in the bar count to that of a
crotchet. The Midi engine would creat a bar with an extra crotchet of silence?
The second solution overcomes this and is much less complicated than a full
staff of dymanics even if it is a bit cumbersome.
Thanks again your suggestions were very clear and succinct unlike my ramblings.
Peter Gentry