[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
adjustment of arc shape according to papersize
From: |
Venus' Wink |
Subject: |
adjustment of arc shape according to papersize |
Date: |
Sat, 20 Jun 2015 00:25:50 -0800 |
Hi All,
Would you see the following to codes?
http://lilybin.com/57gfma/2
http://lilybin.com/57gfma/3
The paper widths, and according to them,
the lists of control points for slurs
differ between these examples.
I'd like to switch the control points
on the paper size in one code as:
If paper-width is 210mm, pass the
control points for 210mm paper width
to \shape.
If paper-width is 297mm, pass the
control points for 297mm paper width
to \shape.
(So far, only for 210mm and for 297mm
are enough.)
How could I realize it?
Thanks
Venus' Wink
____________________________________________________________
FREE 3D EARTH SCREENSAVER - Watch the Earth right on your desktop!
Check it out at http://www.inbox.com/earth
- adjustment of arc shape according to papersize,
Venus' Wink <=