Vadim,
I'm trying to put asterisk and zaptel on a mpc8315erdb. Asterisk
seems to
compiling fine, since I found your .spec file. (Thanks ;) ) I'm
getting a
bunch of assembly code errors in zaptel.
Unfortunately, I can't even see what code is trying to be compiled
here. Any
Ideas?
make[2]: Leaving directory
`/home/bob/BSP/ltib-mpc8315erdb-20080630/rpm/BUILD/zaptel-1.4.11/
menuselect'
make -C /home/bob/BSP/ltib-mpc8315erdb-20080630/rpm/BUILD/linux
ARCH=powerpc
SUBDIRS=/home/bob/BSP/ltib-mpc8315erdb-20080630/rpm/BUILD/
zaptel-1.4.11/kern
el HOTPLUG_FIRMWARE=no KBUILD_OBJ_M="pciradio.o tor2.o torisa.o
wcfxo.o
wct1xxp.o wctdm.o wcte11xp.o wcusb.o zaptel.o ztd-eth.o ztd-loc.o
ztdummy.o
ztdynamic.o zttranscode.o wct4xxp/ wctc4xxp/ xpp/ wctdm24xxp/
wcte12xp/"
modules
make[2]: Entering directory
`/home/bob/BSP/ltib-mpc8315erdb-20080630/rpm/BUILD/linux-2.6.24'
/usr/bin/gcc -o
/home/bob/BSP/ltib-mpc8315erdb-20080630/rpm/BUILD/zaptel-1.4.11/
kernel/makef
w
/home/bob/BSP/ltib-mpc8315erdb-20080630/rpm/BUILD/zaptel-1.4.11/
kernel/makef
w.c
/tmp/ccipHt16.s: Assembler messages:
/tmp/ccipHt16.s:25: Error: Unrecognized opcode: `leal'
/tmp/ccipHt16.s:26: Error: Unrecognized opcode: `andl'
/tmp/ccipHt16.s:27: Error: Unrecognized opcode: `pushl'
/tmp/ccipHt16.s:28: Error: Unrecognized opcode: `pushl'
/tmp/ccipHt16.s:29: Error: Unrecognized opcode: `movl'
Did you ever get some hardware to try this on?
Thanks
Bob Conklin
Rhino Equipment Corp.
address@hidden
Tel: +1 (480) 621-4014 Direct Dial
+1 (480) 621-4000, +1 (877) RHINO-T1, Ext. 6353
FAX: +1 (480) 961-1826
IP: asterisk.rhinoequipment.com x6353
FWD: 633686 x6353
THIS COMMUNICATION MAY CONTAIN CONFIDENTIAL AND/OR OTHERWISE
PROPRIETARY
MATERIAL and is thus for use only by the intended recipient. If you
received this in error, please contact the sender and delete the
email
and its attachments from all computers.