[Ltib] R: Question about file execution

[Roberto Giovoni]

Thank's for your interest about our problem.

Pegasus is an executable file.

The command "file" isn't implemented on our target
but we have executed the command on a linux unbuntu
running on desktop PC.

Attached file containing the results.

                Best Regards
                Giovoni Roberto



-----Messaggio originale-----
Da: Andrea Galbusera [mailto:address@hidden
Inviato: lunedì 18 aprile 2011 8.51
A: Roberto Giovoni
Cc: address@hidden; 'Ronco'
Oggetto: Re: [Ltib] Question about file execution


Roberto,
please, see comments below.

On Fri, 2011-04-15 at 11:21 +0200, Roberto Giovoni wrote:
> We have created a file system image for LPC3250 for Phytec board
> with linux kernel image ver 2.6.34.
>
> We have the following problem:
>
> 1) we have copied in /home/teledata/Pulsar directory our Pegasus
executable
> file
> 2) we start to run this file (always from directory above) with the line
> command ./Pegasus
> 3) we obtain the message ""-/bin/sh: ./Pegasus: not found"

Could you please execute the following commands on the target and attach
the output?
$ ls -l /home/teledata/Pulsar
$ ls -l /bin/sh
$ file /home/teledata/Pulsar/Pegasus

Last command might fail if you don't have the command 'file' available
on your target filesystem. In such a case, is 'Pegasus' an executable or
a shell script file?

Regards,
Andrea

SFProblem.doc
Description: MS-Word document