Re: [Ltib] how to change packages' build sequence

[Lv Terry-R65388]

Hi Christoph,

        Thanks for replying the mail.

        When I ran ./ltib --mode config to configure busybox, it seems ip route 
can't be deselected.

        --- ip
        ---  ip address
        ---  ip link
        ---  ip route
        [*]  ip tunnel

        Do you know why?

        Thanks~~

Yours
Terry

-----Original Message-----
From: address@hidden [mailto:address@hidden On Behalf Of Christoph Baumann
Sent: 2012年7月31日 16:16
To: address@hidden
Subject: Re: [Ltib] how to change packages' build sequence

Hello Terry,

----- Ursprüngliche Mail -----
> Von: "Lv Terry-R65388" <address@hidden>
> An: address@hidden
> Gesendet: Dienstag, 31. Juli 2012 10:04:32
> Betreff: [Ltib] how to change packages' build sequence Hi experts,
> 
> Do you know how to change packages' build sequence?
> 
> In building packages, both busybox and iproute2 will install iproute 
> to /bin in rootfs and we want to use iproute from iproute2.
> 
> Can we let iproute2 build after busybox? Then iproute from iproute2 
> can overwrite it from busybox.

RPM should complain about overwriting files from other packages. Try 
deselecting iproute in the busybox configuration:
Run './ltib --mode config', go to 'Package list', check 'Configure busybox at 
build time'. Then start a build and deselect iproute in busybox' network 
utilities section.


Regards,
Christoph

_______________________________________________
LTIB home page: http://ltib.org

Ltib mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/ltib