ltib
[
Top
][
All Lists
]
Advanced
[
Date Prev
][
Date Next
][
Thread Prev
][
Thread Next
][
Date Index
][
Thread Index
]
[Ltib] (no subject)
From
:
jayanthkumar.m.j kumar
Subject
:
[Ltib] (no subject)
Date
:
Fri, 25 Jan 2013 15:07:51 +0530
Hai,
I am using imx23 evk board and L2.6.31_10.05.02_ER_source(Ltib) BSP to build images,
doing fine with images but not able to get eth0 after i booted from sdcad, while configuring Ltib i selected
boot stream option and i set the ip-address
started networking, enabled Interface 0 and set the ip, broadcast netmask and gateway address
--
Regards
Jayanthkumar
9844598977
reply via email to
[Prev in Thread]
Current Thread
[Next in Thread]
[Ltib] (no subject)
,
jayanthkumar.m.j kumar
<=
Prev by Date:
[Ltib] Build results for 20130124
Next by Date:
[Ltib] Not able to use network device(eth0)in imx23
Previous by thread:
[Ltib] Build results for 20130124
Next by thread:
[Ltib] Not able to use network device(eth0)in imx23
Index(es):
Date
Thread