[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [lwip-users] RE: Performance question
From: |
Matthew Yingling |
Subject: |
RE: [lwip-users] RE: Performance question |
Date: |
Tue, 18 Dec 2007 15:12:30 -0500 |
Current? My copy of EDK 9.2 includes LwIP 1.2.0.
-----Original Message-----
From: address@hidden
[mailto:address@hidden On Behalf Of Paul
Tobias
Sent: Tuesday, December 18, 2007 3:04 PM
To: address@hidden
Subject: [lwip-users] RE: Performance question
Using LWIP 0.8 (the current Xilinx distribution) raw API on a
300 MHz PPC in Xilinx's ML403 development board, but otherwise a very
similar setup to Bill Auerbach's, we can receive about 13 Mbytes/sec
from an old WinXP machine (net payload). This is using programmed
I/O to read the TEMAC FIFOs which is very very slow, so we are moving
to using custom DMA. Lwip processing for a packet takes about
14 microsecs with the TCP checksumming turned off. (I had previously
reported receiving 300-400 Mbps using older drivers, but I now think
that figure was erroneous.)
Paul
www.PaulTobias.com
_______________________________________________
lwip-users mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/lwip-users