Re: [lwip-users] How to check send state?

[Simon Goldschmidt]

Bill, I appreciate you trying to teach programming basics, but I think this won't get Karl Karpfen further: sending from main-loop and receiving in interrupt just won't work with lwIP.

 

Simon

 

Gesendet: Dienstag, 16. September 2014 um 15:43 Uhr
Von: "Bill Auerbach" <address@hidden>
An: "'Mailing list for lwIP users'" <address@hidden>
Betreff: Re: [lwip-users] How to check send state?

Hi,

 

Did you declare sentLength as volatile?  You might also need to protect it if it’s not loaded/stored in a single processor instruction (not likely to be the case with a 32-bit architecture).

 

Bill

 

From: address@hidden [mailto:address@hidden On Behalf Of Karl Karpfen
Sent: Monday, September 15, 2014 3:00 PM
To: address@hidden
Subject: [lwip-users] How to check send state?

 

Hi,

within my lwIP application (TCP with permanent connection) I'm sending some data out of main-loop (no interrupt context) and start submission by calling

tcp_output(currentPcb);

Sending of data is done via tcp_write(). Within the send function itself amount of data already sent is stored in a variable sentLength. Now to find out if it is possible to send next bunch of data I check this variable. When its size is equal to the length of the previous data buffer, sending was completed and I start submission of next buffer.

 

My problem here: sentLength is manipulated out of interrupt context while checking it for completion is done out of main loop. It seems this sometimes causes troubles, at receiver side I can see incomplete frames.

So my question: what is the correct way to find out if currentPcb has finished sending (or better has pushed all data to tcp_write()) and is ready to accept next bunch of data?

Thanks!

_______________________________________________ lwip-users mailing list address@hidden https://lists.nongnu.org/mailman/listinfo/lwip-users