[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: lynx-dev lynx2.8.5dev.4
From: |
Thomas Dickey |
Subject: |
Re: lynx-dev lynx2.8.5dev.4 |
Date: |
Thu, 8 Nov 2001 19:14:20 -0500 |
User-agent: |
Mutt/1.2.5i |
On Fri, Nov 09, 2001 at 12:30:11AM +0100, Michel SUCH wrote:
> On Thu, 8 Nov 2001 16:09:39 -0500, Thomas Dickey wrote:
>
> >* correct the following names in LYrcFile.c which were added to allow
> > ENABLE_LYNXRC lines in lynx.cfg to enable them to be saved in ~/.lynxrc
> > old new where-used
> > -------------------------------------
> > DTD_recovery tagsoup (command-line option and lynx.cfg)
> > show_rate show_kb_rate (lynx.cfg)
> > user_agent useragent (command-line option)
>
> This still does not seem to work, at least for DTD_recovery tagsoup.
> Even if setting the following in lynx.cfg:
> ENABLE_LYNXRC:tagsoup:ON
> the (!) remains before the option in the
> option menu. I can probably save it but it is not reapplied when reloading
> LYNX.
I'll double-check. When you first reported this, I recalled noting that
there was some problem, but when I tested this on the weekend, I was able
to save/restore the value, so I didn't look further. Just a quick check
shows the '!', but that I can save/restore the value:
===================================================================
RCS file: RCS/.lynxrc,v
retrieving revision 1.3
diff -r1.3 .lynxrc
287c287,290
< sub_bookmarks=standard
---
> sub_bookmarks=ADVANCED
>
> # Normally disabled. See ENABLE_LYNXRC in lynx.cfg
> tagsoup=on
--
Thomas E. Dickey <address@hidden>
http://invisible-island.net
ftp://invisible-island.net
; To UNSUBSCRIBE: Send "unsubscribe lynx-dev" to address@hidden