RE: [microdc-devel] Auto connexion

[Vladimir Chugunov]

Hi,

in case you are using microdc2 use "set auto_reconnect on" command to enable 
automatic reconnection to a hub.
The original microdc has no ability to reconnect to a hub automatically.

Regards, Vladimir.

> -----Original Message-----
> From: 
> address@hidden 
> [mailto:address@hidden
> org]On Behalf Of Daeavelwyn
> Sent: Saturday, February 17, 2007 1:59 PM
> To: address@hidden
> Subject: [microdc-devel] Auto connexion
> 
> 
> Hi everyone!
> 
> A little question, microdc can auto reconect to a hub ??
> I'm disconnected from my hub and i'm a bit frustrated tha 
> microdc doesn't 
> reconnect automaticly :/ . 
> 
> If someone coul indicate the command to configure auto 
> reconnexion, if this 
> command exist ^_^. Otherwise, perhaps some nice developper 
> could implement 
> it :D
> 
> See ya,
> Dae.
> 
> 
> _______________________________________________
> microdc-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/microdc-devel
>