Re: Correct method to monitor service?

[frwa onto]

Hi Martin

             I got this error now when I did this monit start service1 ? Where to add the 'set httpd statement"?

Action start not possible - monit http interface is not enabled, please add the 'set httpd' statement ? Should I start using monit start command or can I use the existing method to start it? Which the correct one?

On Mon, Nov 9, 2015 at 11:27 PM, Martin Pala <address@hidden> wrote:

Hi,

correct syntax is:

        monit start service1

Regards,
Martin

> On 09 Nov 2015, at 16:23, frwa onto <address@hidden> wrote:
>
> Hi,
>     I have set below in my monit.conf.
>
> check process service1 with pidfile /var/run/wrapper.service1.pid
>               start program = "/etc/rc.d/init.d/service1 start" with timeout 60 seconds
>               stop program = "/etc/rc.d/init.d/service1 stop"
>
> I tried to start the service in this manner
> monit service1 start
> Invalid argument -- service1 (-h will show valid arguments)
>
> So should I start using my existing method where I get into my wrapper folder /usr/local/wra1/bin/ then key in ./startDaemon.sh? I would like to know if I am doing the right thing?
>
> Thank  you.
>

> --
> To unsubscribe:
> https://lists.nongnu.org/mailman/listinfo/monit-general


--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general