[Octave-bug-tracker] [bug #35761] surf() fails when Z values are within eps of each other

[Rik]

Follow-up Comment #9, bug #35761 (project octave):

I'm adding Ben to the bug list.  I swear that we addressed some similar issue
with %g not producing the correct output and we made a similar change.  If
that could be confirmed then I think this is the way to go.

Also, in the ancient changelogs there was some confusion about wether %g or %e
should be used.

+2007-09-21  John W. Eaton  <address@hidden>
+
+       * optimization/sqp.m: Fix typo.
+
+       * plot/__go_draw_axes__.m (do_tics_1): Use %g, not %.15g here.

+2007-09-18  David Bateman  <address@hidden>
+
+       * plot/__go_draw_axes__.m (__gnuplot_write_data__): Use %e instead
+       of %g when writing data.

+2005-11-22  John W. Eaton  <address@hidden>
+
+       * plot/axis.m: Use %.16g instead of just %g to format ranges for
+       gnuplot set command.



    _______________________________________________________

Reply to this item at:

  <http://savannah.gnu.org/bugs/?35761>

_______________________________________________
  Message sent via/by Savannah
  http://savannah.gnu.org/