[Octave-bug-tracker] [bug #40792] gui not working on ubuntu 12.04

[anonymous]

Follow-up Comment #4, bug #40792 (project octave):

I have made a new build of octave with stable branch
and have the same problem as before . result of hg id :
2bdd8cea6585 (stable) tip
built with --enable-jit --prefix=/media/western/install_dir/octave
after building I ran tests and get :
1 fail
7 x fail
11522 pass
installed and removed ./config/octave
i launch octave-gui with the command
/media/western/install_dir/octave/bin/octave-gui from a terminal
octave shows welcome i accept finish and i get the gui
then every command i type goes to the terminal i used to launch octave even if
i double click over the gui.
if i use a command from the command history on the left
it works ok 
for example 
t=linspace(-1,1,10000); <- command already in my history
plot(t,sin(1./t)) <- command already in my history
it plots fine but after that even if i close
the plot window the gui doesn't respond
double clicking again on the left command history 
makes the gui responsive again
i hope this clarifies a little what's goin on.
regards 
joaquin



    _______________________________________________________

Reply to this item at:

  <http://savannah.gnu.org/bugs/?40792>

_______________________________________________
  Message sent via/by Savannah
  http://savannah.gnu.org/