[Octave-bug-tracker] [bug #48478] print.m incorrect check if axes exist

[Rik]

Update of bug #48478 (project octave):

                  Status:                    None => Fixed                  
             Open/Closed:                    Open => Closed                 

    _______________________________________________________

Follow-up Comment #2:

The test is correct.  Octave needs at least one axes object immediately below
the figure in order to print.  Matlab may be less finicky, but for the moment
I'm okay with that restriction.

This is certainly a typo so I corrected it here
(http://hg.savannah.gnu.org/hgweb/octave/rev/4c0f78b3c86f).

Closing report.


    _______________________________________________________

Reply to this item at:

  <http://savannah.gnu.org/bugs/?48478>

_______________________________________________
  Message sent via/by Savannah
  http://savannah.gnu.org/