octave-maintainers
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: build failure


From: c.
Subject: Re: build failure
Date: Fri, 14 Sep 2012 20:57:31 +0200

On 14 Sep 2012, at 19:28, John W. Eaton wrote:

> On 14-Sep-2012, c. wrote:
> 
> | John,
> | not much, I seem to be getting the same errors, in particular gcc is still 
> used for linking rather than g++:
> | /bin/sh ../libtool --tag=CC   --mode=link ccache gcc-4.2
> | I'm not sending the whole verbose output again unless you need it.
> | Thanks for your help, any other suggestions I could try, maybe configuring 
> with LD=g++?
> | c.
> 
> Hmm, for me that change caused g++ to be used to link liboctave.
> There was a typo for the libgui/Makefile.am.  I wrote libgui in one
> place where I should have had liboctgui.  I checked in a corrected
> version of that change.
> 
> What version of automake are you using?  I have 1.11.6.
> 
> jwe

guglielmo.local $ automake --version
automake (GNU automake) 1.11.3
Copyright (C) 2011 Free Software Foundation, Inc.
License GPLv2+: GNU GPL version 2 or later 
<http://gnu.org/licenses/gpl-2.0.html>
This is free software: you are free to change and redistribute it.
There is NO WARRANTY, to the extent permitted by law.

Written by Tom Tromey <address@hidden>
       and Alexandre Duret-Lutz <address@hidden>.

I'll try to update and see whether that changes anything.
c.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]