Re: GEN doc/interpreter/gplot.txt

[Ben Abbott]

> On Feb 29, 2016, at 11:17 PM, Ben Abbott <address@hidden> wrote:
> 
>> On Feb 29, 2016, at 2:11 PM, Ben Abbott <address@hidden> wrote:
>> 
>>> On Feb 29, 2016, at 13:28, Mike Miller <address@hidden> wrote:
>>> 
>>>> On Sat, Feb 27, 2016 at 18:12:30 -0500, Ben Abbott wrote:
>>>> The make process is starting hanging for me while building 
>>>> doc/interpreter/gplot.txt
>>>> 
>>>> Does anyone else see this?
>>> 
>>> I don't, but I do occasionally see segfaults in building one or more of
>>> the plots in doc/interpreter.
>>> 
>>> Hanging or crashing?
>>> 
>>> Something particular about that specific plot script?
>> 
>> I had been seeing the same as you until I switched to building the stable 
>> branch for a week or so and returned to default.
>> 
>> Perhaps I should go back to stable and see what happens
>> 
>> Ben
> 
> After pulling, my build still segfaults, but does not hang.
> 
> panic: Segmentation fault: 11 -- stopping myself...
> attempting to save variables to 'octave-workspace'...
> save to 'octave-workspace’ complete
> 
> After switching to stable, I get just about to the end before make fails.
> 
>  TEXI2DVI octave.dvi
> /sw/bin/texi2dvi: etex exited with bad status, quitting.
> Makefile:2150: recipe for target 'octave.dvi' failed
> make[3]: *** [octave.dvi] Error 1
> 
> Ben

Additionally, I’m unable to run the gui when building default (Octave runs, but 
the gui never appears), but am able to run the gui with the stable branch.

Ben