paparazzi-devel
[
Top
][
All Lists
]
Advanced
[
Date Prev
][
Date Next
][
Thread Prev
][
Thread Next
][
Date Index
][
Thread Index
]
[Paparazzi-devel] help with 'BOARD_CONFIG' error
From
:
BX Guan
Subject
:
[Paparazzi-devel] help with 'BOARD_CONFIG' error
Date
:
Tue, 13 Jul 2010 14:11:06 +0930
Hey, not even sure whether this is the correct way of asking a question, but here goes:
After installing and updating to the newest Paparazzi, I had a problem where the GCS says that I must have a "filename" or <filename> after #include
And I managed to find out that the problem is with the sys_time.h file under paparazzi3>sw>airborne.
Searching the mailing list archive I found an instruction that says I should change a line in the "makefile" section of my airframe file to:"
ap.CFLAGS += -DFBW -DAP -DBOARD_CONFIG=$(CONFIG) -DLED -DTIME_LED=1
I've done the change, and noticed that I'm still getting an error of:
make[1]: *** No rule to make target `BOARD_CONFIG', needed by `/home/bao/paparazzi3/var/MJ5/ap/sys_time.o'. Stop.
I have since realized that the problem is consistent even if I try to build the MJ5 or TJ1 airframes.
Any ideas?
Thanks,
Bao
reply via email to
[Prev in Thread]
Current Thread
[
Next in Thread
]
[Paparazzi-devel] help with 'BOARD_CONFIG' error
,
BX Guan
<=
[Paparazzi-devel] Re: help with 'BOARD_CONFIG' error
,
BX Guan
,
2010/07/13
Prev by Date:
Re: [Paparazzi-devel] Electrical connections in the airborne equipment.
Next by Date:
Re: [Paparazzi-devel] Strange Surging Behavior
Previous by thread:
[Paparazzi-devel] Electrical connections in the airborne equipment.
Next by thread:
[Paparazzi-devel] Re: help with 'BOARD_CONFIG' error
Index(es):
Date
Thread