[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Paparazzi-devel] re: Razor IMU Wiring Diagram
From: |
Simon Wilks |
Subject: |
Re: [Paparazzi-devel] re: Razor IMU Wiring Diagram |
Date: |
Tue, 25 Jan 2011 13:56:00 +0100 |
So in the case of Ana:
ADC_0 = IRV connector (pin 3)
ADC_1 = IRH connector (pin 4)
ADC_2 = IRH connector (pin 3)
ADC_3 = ADC1 connector (pin 5)
ADC_4 = ADC1 connector (pin 4)
ADC_5 = ADC2 connector (pin 5)
And power can come off any of the connector's 3.3v pins. Ground from
any ground pin. Correct?
In example_twog_analogimu.xml it uses the first three above but in
place of the last three it uses:
ADC_5 = ADC2 connector (pin 5)
ADC_6 = ADC2 connector (pin 4)
ADC_7 = USB connector (pin 8) really?
Also good? Does it matter which combination I use as long as whatever
I take is defined in the config?
Thanks,
Simon
On Tue, Jan 25, 2011 at 10:32 AM, Christoph Niemann
<address@hidden> wrote:
> Hi,
>
> I also use a TWOG and a Razor IMU like you. In my case it works. You have to
> connect the accel and gyro channels according to you r configuration file.
> Needles to say, you have to connect the 3.3V and GND rail. You might have to
> remove the highpasses from your IMU, if you have the old version (see the
> schematic). The most important thing is, that you have to bridge the
> resistors in line of the Voltage deviders on you twog. And you have to
> remove the resistors to GND (also see schematic of the twog).
> As I wrote some times before I for myself am still using the SW in my pretty
> old branch, but it is working. For more information see
> http://paparazzi.enac.fr/wiki/User:Christoph .
>
> Good Luck
>
> Christoph
>
> Am 25.01.2011 08:32 schrieb "GARCIA ALVAREZ, ANA" <address@hidden>:
>
> Hi,
>
> I have a tiny 2.11 and a Razor IMU(still not working). But I have wired the
> outputs from accelerometers(Ax, Ay, Az) and gyros(Gx, Gy, Gz) to ADCS in the
> tiny(in my case, ADC0…ADC5). Then I have wired GND an 3.3V to the tiny too.
> Finally, in the flight plan I have defined which ADC is everyone in the
> firmware section (subsystem: imu)-you can see an example in
> conf/example_twog_analogimu.
>
> Hope this helps.
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>