Hello,
I use a Tiny v2.11 autopilot wired according to this
diagram. I am using the PPM method with a Futaba T6EXAP
transmiter (radio) and a Futaba R136F Receiver. The autopilot works
fine at the AUTO 2 mode with the PPM's LED staying constantly on.
When powering on the transmiter, the PPM's LED works as expected
blinking at 3Hz but I can't turn to manual mode nor with the
3-possition switch nor by turning to manual mode via the CGS. The
servo wont do anything when I am moving the transmiter' s sticks.
Any ideas?
|