|
From: | Eduardo lavratti |
Subject: | Re: [Paparazzi-devel] Lisa M wiring layout |
Date: | Sat, 31 Dec 2011 20:03:01 +0000 |
Bruzzlee, i am using lisa/m too.
Please, report your tests to the group. I have strange behavior with my copter. Some of this caused by vibration and other that i not know the cause. regards. > From: address@hidden > Date: Sun, 1 Jan 2012 01:46:19 +1030 > To: address@hidden > Subject: Re: [Paparazzi-devel] Lisa M wiring layout > > Hi Bruzzlee > > It looks good to me and yes the ADC1 bridge is needed only for the initial bind to the Spektrum receiver (or receivers, you can use two at once) > > Eric > > On 30/12/2011, at 7:51 AM, Bruzzlee wrote: > > > Hi all > > After a long break I've continued the work on my quadrotor Lisa M project. Now I've done my wiring layout but I'm not sure if everything is correct. > > Especially the power source for the board: I2C1 CAN (V_BATT/GND) or SERVO1 (SV/GND)? > > The ADC1 bridge - I need it only for the first binding to the spectrum remote - right? > > > > I want to publish this layout on wiki - please report mistakes! > > > > thx > > Bruzzlee > > <LisaMWiring.png>_______________________________________________ > > Paparazzi-devel mailing list > > address@hidden > > https://lists.nongnu.org/mailman/listinfo/paparazzi-devel > > > _______________________________________________ > Paparazzi-devel mailing list > address@hidden > https://lists.nongnu.org/mailman/listinfo/paparazzi-devel |
[Prev in Thread] | Current Thread | [Next in Thread] |