[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-arm] [PATCH v2 0/5] ARM: Machine specific boot blobs
From: |
Peter Maydell |
Subject: |
Re: [Qemu-arm] [PATCH v2 0/5] ARM: Machine specific boot blobs |
Date: |
Fri, 30 Oct 2015 20:44:51 +0000 |
On 30 October 2015 at 05:34, Peter Crosthwaite
<address@hidden> wrote:
> Hi,
>
> This adds support for machine-specific primary boot blobs. This can be
> used to install little bits of firmware or boot code without having
> to throw the whole QEMU bootloader out and BYO (with device drivers
> and all).
>
> It is then used to fix two boards, Zynq and Highbank, both which have
> small but critical expectations of pre-boot software setup.
>
> Regards,
> Peter
>
> Changed since v1:
> Addressed PMM review.
> Added secure_board_setup flag (P4)
> Added Zynq patch first, then Highbank
> See indiv. patches for detailed change logs.
>
>
> Peter Crosthwaite (5):
> arm: boot: Adjust indentation of FIXUP comments
> arm: boot: Add board specific setup code API
> arm: xilinx_zynq: Add linux pre-boot
> arm: boot: Add secure_board_setup flag
> arm: highbank: Implement PSCI and dummy monitor
Patches 1..3 are OK and I've put them in target-arm.next.
Patches 4 and 5 I have comments on.
thanks
-- PMM
[Qemu-arm] [PATCH v2 5/5] arm: highbank: Implement PSCI and dummy monitor, Peter Crosthwaite, 2015/10/30
Re: [Qemu-arm] [PATCH v2 0/5] ARM: Machine specific boot blobs,
Peter Maydell <=