[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-block] [PATCH v2 2/2] AHCI: Protect cmd register
From: |
John Snow |
Subject: |
[Qemu-block] [PATCH v2 2/2] AHCI: Protect cmd register |
Date: |
Fri, 13 Mar 2015 17:50:54 -0400 |
Many bits in the CMD register are supposed to be strictly read-only.
We should not be deleting them on every write.
As a side-effect: pay explicit attention to when a guest marks off
the FIS Receive or Start bits, and disable the status bits ourselves,
instead of letting them implicitly fall off.
Signed-off-by: John Snow <address@hidden>
---
hw/ide/ahci.c | 26 +++++++++++++++++++++++++-
hw/ide/ahci.h | 2 ++
2 files changed, 27 insertions(+), 1 deletion(-)
diff --git a/hw/ide/ahci.c b/hw/ide/ahci.c
index 3885fa9..df8c083 100644
--- a/hw/ide/ahci.c
+++ b/hw/ide/ahci.c
@@ -53,6 +53,8 @@ static int ahci_dma_prepare_buf(IDEDMA *dma, int is_write);
static void ahci_commit_buf(IDEDMA *dma, uint32_t tx_bytes);
static bool ahci_map_clb_address(AHCIDevice *ad);
static bool ahci_map_fis_address(AHCIDevice *ad);
+static void ahci_unmap_clb_address(AHCIDevice *ad);
+static void ahci_unmap_fis_address(AHCIDevice *ad);
static uint32_t ahci_port_read(AHCIState *s, int port, int offset)
@@ -223,7 +225,9 @@ static void ahci_port_write(AHCIState *s, int port, int
offset, uint32_t val)
ahci_check_irq(s);
break;
case PORT_CMD:
- pr->cmd = val & ~(PORT_CMD_LIST_ON | PORT_CMD_FIS_ON);
+ /* Block any Read-only fields from being set;
+ * including LIST_ON and FIS_ON. */
+ pr->cmd = (pr->cmd & PORT_CMD_RO_MASK) | (val & ~PORT_CMD_RO_MASK);
if (pr->cmd & PORT_CMD_START) {
if (ahci_map_clb_address(&s->dev[port])) {
@@ -232,6 +236,9 @@ static void ahci_port_write(AHCIState *s, int port, int
offset, uint32_t val)
error_report("AHCI: Failed to start DMA engine: "
"bad command list buffer address");
}
+ } else if (pr->cmd & PORT_CMD_LIST_ON) {
+ ahci_unmap_clb_address(&s->dev[port]);
+ pr->cmd = pr->cmd & ~(PORT_CMD_LIST_ON);
}
if (pr->cmd & PORT_CMD_FIS_RX) {
@@ -241,6 +248,9 @@ static void ahci_port_write(AHCIState *s, int port, int
offset, uint32_t val)
error_report("AHCI: Failed to start FIS receive engine: "
"bad FIS receive buffer address");
}
+ } else if (pr->cmd & PORT_CMD_FIS_ON) {
+ ahci_unmap_fis_address(&s->dev[port]);
+ pr->cmd = pr->cmd & ~(PORT_CMD_FIS_ON);
}
/* XXX usually the FIS would be pending on the bus here and
@@ -575,6 +585,13 @@ static bool ahci_map_fis_address(AHCIDevice *ad)
return ad->res_fis != NULL;
}
+static void ahci_unmap_fis_address(AHCIDevice *ad)
+{
+ dma_memory_unmap(ad->hba->as, ad->res_fis, 256,
+ DMA_DIRECTION_FROM_DEVICE, 256);
+ ad->res_fis = NULL;
+}
+
static bool ahci_map_clb_address(AHCIDevice *ad)
{
AHCIPortRegs *pr = &ad->port_regs;
@@ -584,6 +601,13 @@ static bool ahci_map_clb_address(AHCIDevice *ad)
return ad->lst != NULL;
}
+static void ahci_unmap_clb_address(AHCIDevice *ad)
+{
+ dma_memory_unmap(ad->hba->as, ad->lst, 1024,
+ DMA_DIRECTION_FROM_DEVICE, 1024);
+ ad->lst = NULL;
+}
+
static void ahci_write_fis_sdb(AHCIState *s, int port, uint32_t finished)
{
AHCIDevice *ad = &s->dev[port];
diff --git a/hw/ide/ahci.h b/hw/ide/ahci.h
index 99aa0c9..501c002 100644
--- a/hw/ide/ahci.h
+++ b/hw/ide/ahci.h
@@ -132,6 +132,8 @@
#define PORT_CMD_ICC_PARTIAL (0x2 << 28) /* Put i/f in partial state */
#define PORT_CMD_ICC_SLUMBER (0x6 << 28) /* Put i/f in slumber state */
+#define PORT_CMD_RO_MASK 0x007dffe0 /* Which CMD bits are read only?
*/
+
/* ap->flags bits */
#define AHCI_FLAG_NO_NCQ (1 << 24)
#define AHCI_FLAG_IGN_IRQ_IF_ERR (1 << 25) /* ignore IRQ_IF_ERR */
--
1.9.3