[Qemu-block] [PATCH 11/16] libqos/ahci: edit wait to be ncq aware

[John Snow]

The wait command should check to make sure SACT is clear as well
as the Command Issue register.

Signed-off-by: John Snow <address@hidden>
---
 tests/libqos/ahci.c | 10 +++++++---
 1 file changed, 7 insertions(+), 3 deletions(-)

diff --git a/tests/libqos/ahci.c b/tests/libqos/ahci.c
index 9a4d510..da02e2e 100644
--- a/tests/libqos/ahci.c
+++ b/tests/libqos/ahci.c
@@ -908,11 +908,15 @@ void ahci_command_wait(AHCIQState *ahci, AHCICommand *cmd)
     /* We can't rely on STS_BSY until the command has started processing.
      * Therefore, we also use the Command Issue bit as indication of
      * a command in-flight. */
-    while (BITSET(ahci_px_rreg(ahci, cmd->port, AHCI_PX_TFD),
-                  AHCI_PX_TFD_STS_BSY) ||
-           BITSET(ahci_px_rreg(ahci, cmd->port, AHCI_PX_CI), (1 << 
cmd->slot))) {
+
+#define RSET(REG, MASK) (BITSET(ahci_px_rreg(ahci, cmd->port, (REG)), (MASK)))
+
+    while (RSET(AHCI_PX_TFD, AHCI_PX_TFD_STS_BSY) ||
+           RSET(AHCI_PX_CI, 1 << cmd->slot) ||
+           (cmd->props->ncq && RSET(AHCI_PX_SACT, 1 << cmd->slot))) {
         usleep(50);
     }
+
 }
 
 void ahci_command_issue(AHCIQState *ahci, AHCICommand *cmd)
-- 
2.1.0