Re: [Qemu-devel] 2.6 kernel + new timing code + kqemu (-kernel-kqemu)

[Lonnie Mendez]

On Fri, 2006-07-14 at 20:50 +0200, Fabrice Bellard wrote:
> Lonnie Mendez wrote:
> > I ran a limited test with the new code to see what works.  All tests run
> > with kqemu enabled binary (1.3.0pre9).  Host is a laptop w/ pentium 3
> > mobile processor running ubuntu linux.
> > 
> > deb-sid (2.6.17-1-686 SMP):
> > 
> > qemu -hda deb-sid.qcow -no-kqemu
> >    boots to login prompt
> > 
> > qemu -hda deb-sid.qcow
> >     boots to login prompt
> > 
> > qemu -hda deb-sid.qcow -kernel-kqemu
> >     hangs on boot with:
> >        
> >   hda: QEMU HARDDISK, ATA DISK drive
> >   ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> >   hdc: QEMU CD-ROM, ATAPI CD/DVD-ROM drive
> >   ide1 at 0x170-0x177,0x376 on irq 15
> >   hda: max request size: 512KiB
> >   hda: 6291456 sectors (3221 MB) w/256KiB Cache, CHS=6241/255/63, (U)DMA
> >   hda: lost interrupt
> >   hda: lost interrupt
> >   hda: lost interrupt
> >   hda: set_multmode: status=0x41 { DriveReady Error }
> >   hda: set_multmode: error=0x04 { DriveStatusError }
> >   ide: failed opcode was: 0xef
> >   ... hangs ...
> 
> Did you have the same problem before the timer patch ?

  No.  The problem is not evident with qemu 0.8.1 release and CVS
checkouts from before the timer patch.