Re: [Qemu-devel] [RFC][PATCH] fix sparc32 mxcc 64 bit read word order

[Blue Swirl]

On 11/18/07, Robert Reif <address@hidden> wrote:
> Blue Swirl wrote:
>
> >On 11/16/07, Robert Reif <address@hidden> wrote:
> >
> >
> >>>This patch fixes the word order for 64 bit reads of the mxcc registers.
> >>>
> >>>
> >
> >Otherwise everything seems OK, but it breaks NetBSD version 3 on SS10:
> >clock0 at obio0 slot 0 offset 0x200000: mk48t08
> >timer0 at obio0 slot 0 offset 0x300000data fault: pc=0xf0111a0c
> >addr=0x0 sfsr=126<PERR=0,LVL=1,AT=1,FT=1,FAV,OW>
> >panic: kernel fault
> >halted
> >
> >halt, power off
> >
> >Without the patch I get:
> >clock0 at obio0 slot 0 offset 0x200000: mk48t08
> >timer0 at obio0 slot 0 offset 0x300000: delay constant 99
> >zs0 at obio0 slot 0 offset 0x100000 level 12 softpri 6
> >zstty0 at zs0 channel 0 (console i/o)
> >zstty1 at zs0 channel 1
> >scsi-disk: Unsupported command length, command 79
> >
> >
> >
> >
> >
> This is a classic case of two wrongs make a right.  OpenBios need to be
> fixed to set mbus module id to start at 8, not 0 for mbus based machines.

Turbosparc manual says that the module id is hardwired to 0x8, so
would it be OK if mid was  i + 8 for all machines?