[Qemu-devel] [PATCHv4-repost 1/2] qemu: make cirrus init value pci spec compliant

[Michael S. Tsirkin]

PCI memory should be disabled at reset, otherwise
we might claim transactions at address 0.
I/O should also be disabled, although for cirrus
it is harmless to enable it as we do not
have I/O bar.

Note: bios fix needed for this patch to work
was already applied:
previously bios incorrently assumed that it does not
need to enable i/o unless device has i/o bar.

Signed-off-by: Michael S. Tsirkin <address@hidden>
---
 hw/cirrus_vga.c |    1 -
 1 files changed, 0 insertions(+), 1 deletions(-)

diff --git a/hw/cirrus_vga.c b/hw/cirrus_vga.c
index 9390d2c..89ffdf9 100644
--- a/hw/cirrus_vga.c
+++ b/hw/cirrus_vga.c
@@ -3249,7 +3249,6 @@ static int pci_cirrus_vga_initfn(PCIDevice *dev)
      /* setup PCI */
      pci_config_set_vendor_id(pci_conf, PCI_VENDOR_ID_CIRRUS);
      pci_config_set_device_id(pci_conf, device_id);
-     pci_conf[0x04] = PCI_COMMAND_IOACCESS | PCI_COMMAND_MEMACCESS;
      pci_config_set_class(pci_conf, PCI_CLASS_DISPLAY_VGA);
      pci_conf[PCI_HEADER_TYPE] = PCI_HEADER_TYPE_NORMAL;
 
-- 
1.6.5.2.143.g8cc62